How to make photo frame slits
If your frame has more or less than 4 sides, you need some more advanced geometry and math skills not covered in this article. Design a custom sized matboard to fit a picture frame to fit any photos or. Before you cut it check your math and measure again, add the allowance, and if the mark is the same, chop away at 45 degrees. It is a standard of the industry that a 16 x 20 frame will measure inside 16.125 x 20.125 inches. The 1/8" allowance you added before the cut is in case the glass or the art is not perfectly square. This way there is no confusion about which side of the mark the blade take off. The 1/8" wide mark represents the 1/8" wide cut your blade will make. Nail the leg to the top arm of your stand. Tap on the nails with your hammer to sink them into the wood, creating 2 sturdy arms for your picture frame stand. After the wood glue dries, position two 1 in (2.5 cm) nails on the front and back of each arm. This is where your blade needs to be to cut the correct length. Hammer 2 nails into each arm to make them extra secure. This is basically a long piece of nylon with a clamp on the one side. Carefully is a key work in that sentence In order to keep the frame together I also used a band clamp. Carefully drill them into the corners of the back of your frame. Put a mark on the outside edge of the frame between 21 and 5/8" and 21 and 3/4. Make sure you find screws short enough that they won’t go all the way through to the front of your frame.
#HOW TO MAKE PHOTO FRAME SLITS HOW TO#
Now when you pull your tape measure from the point you already mitered towards the end you need to cut you look for 21.5 inches but then add 1/8" allowance for fit. How to make a picture frame sled for perfect miters every time This genius sled eliminates math when trying to determine the length because it measures from. If you had a 16 x 20 artwork and a 3 inch moulding with a 1/4" rabbet, you would be adding 2.75" twice or 5.5" inches, so you would add up to 21.5" x 25.5".
Do not try to measure inside the frame it is not accurate. The length of the miter is equal to the width outside of the rabbet. Add twice the width of the moulding not counting the rabbet width. Forget the rough measures when you purchased the wood. Now to figure your final miter cuts you need to know the outside to outside length of the moulding, corner to corner. Cut your miters at one end of each of the four pieces without taking off more than one inch.